saltar al contenido
Envío gratuito al Reino Unido. Pronto lanzamiento en Europa y EE. UU.

Installing The Brake

img
Step 1

Place your RGS-3 3Style® scooter upside down on a table or similar surface.

 
img
Step 2

Remove the 8 screws located on the base of the scooter.

 
img
Step 3

Once the screws have been removed, turn the scooter the right way up.

 
img
Step 4

Unfold the handlebars to the upright position.

 
img
Step 5

Lift the coloured plastic up over the brake as shown in this picture. This will then expose the screws keeping the brake in place.

 
img
Step 6

Remove both of these screws.

 
img
Step 7

Remove the brake or if the brake has snapped off, remove the remainder of the brake plate.

img
Step 8

Once the brake has been removed, stand the scooter on the handlebars so that the rear wheel is facing upwards. Then pull out the bottom block of the brake.

 
img
Step 9

Put the new brake block into place.

 
img
Step 10

Position the new top part of the brake onto the scooter.

 
img
Step 11

Put the small nuts of the replacement screws into the recess of the brake block and hold these into place so that they don’t fall out.

img
Step 12

While still holding the nuts in place with one hand, use your other hand to screw the new brake securely onto the scooter.

 
img
Step 13

Once the brake has been attached, put the top part of the base back into place.

 
img
Step 14

Screw the 8 screws back into the base of the scooter.