Screw the 8 screws back into the base of the scooter.
Installing The Brake
Step 1
Place your RGS-3 3Style® scooter upside down on a table or similar surface.
Step 2
Remove the 8 screws located on the base of the scooter.
Step 3
Once the screws have been removed, turn the scooter the right way up.
Step 4
Unfold the handlebars to the upright position.
Step 5
Lift the coloured plastic up over the brake as shown in this picture. This will then expose the screws keeping the brake in place.
Step 6
Remove both of these screws.
Step 7
Remove the brake or if the brake has snapped off, remove the remainder of the brake plate.
Step 8
Once the brake has been removed, stand the scooter on the handlebars so that the rear wheel is facing upwards. Then pull out the bottom block of the brake.
Step 9
Put the new brake block into place.
Step 10
Position the new top part of the brake onto the scooter.
Step 11
Put the small nuts of the replacement screws into the recess of the brake block and hold these into place so that they don’t fall out.
Step 12
While still holding the nuts in place with one hand, use your other hand to screw the new brake securely onto the scooter.
Step 13
Once the brake has been attached, put the top part of the base back into place.
Step 14