Installing Height Adjust Button

 

The allen keys required for this instruction guide were provided with your original purchase along with the instruction manual.

Other Allen Keys of the correct size will also work.

You will also need a pair of long pliers or something similar to remove the height adjust button from the handlebars.

img
Step 1

Open the collar clasp on your scooter.

 
img
Step 2

Loosen but do not remove the large screw on the collar clasp using the largest allen key provided.

 
img
Step 3

Then remove the small screw on the collar clasp using the smallest allen key provided and put to one side.

 
img
Step 4

Lift up the collar clasp

 
img
Step 5

Push in the height adjust button and then pull the T-bar out from the handlebar stem. Put the collar clasp to one side.

 
img
Step 6

If the button is jammed inside the scooter you will be able to locate the button inside of the top T-bar.

 

Using long pliers or something similar push the button back into place.

img
Step 7

If the button has come out of place and is not located inside the T-bar, remove the height adjust button spring using long pliers.

Once removed you can then put into place your new button.

Make sure that the button is on the same side as the hole on the T-bar and that the curved side of the spring goes in first. Push the button into the T-bar until it pops out into place.

img
Step 8

There are two plastic sleeves located on the T-bar. The smaller plastic sleeve goes at the bottom of the handlebar stem. The height adjust button goes through the hole on this sleeve.

 
img
Step 9

There is a small inner piece of plastic on this sleeve. This slots into the recess on the T-bar. This is then twisted to secure into place.

 
img
Step 10

Put the collar clasp onto the T-bar and then place the T-bar back into the handlebar stem.

The side of the collar clasp that the small screw goes through is placed on the side with the small recess in the handlebar stem (opposite side to the height adjust button).

When closed the front of the clasp should be on the front of the handlebar stem.

img
Step 11

The larger plastic sleeve goes on next.

The lip of this should face the top of the handlebars and this rests on top of the handlebar stem.

The side with the full slit down faces the side with the height adjust button.

img
Step 12

Screw back in the small screw on the collar clasp.

 
img
Step 13

Tighten the larger screw on the collar clasp to secure this into place and then finally shut the clasp to provide extra tension.

This should be firm to close to prevent any movement on this joint.

What are you looking for?

Your cart