Finally secure the bolts and screws tightly into place.
Installing Spring Assembly
You will have originally been provided with an Allen Key / Screwdriver tool that will be needed for this repair.
Other Screwdrivers and Allen Keys of the correct size will also work.
Place your 3Style Scooter® on a table or similar surface upside-down, this will allow you to have easy access to the bottom of the front of the scooter / steering column.
Remove the two bolts located at the top going through the metal plate.
Then remove the small screws which also go through the metal plate.
Take off the metal plate.
Remove the plastic guard.
Pull the wheel axle off from the base and put these to one side.
Remove any remainder of the spring. You can use one of your allen keys to help ease this out.
Once the spring has been removed, set aside the scooter for now and retrieve your wheel axial.
Remove the small screws located on the axle which secure the wheels in place as seen in this picture.
Once the screws have been removed you can discard the plastic assembly. Before this is thrown please make sure to remove remove the small nuts on the old spring assembly as these will be needed on your new one.
Put the screw through one of the wheel axial’s. Push this through the side where the plastic is flat around the hole. The small metal washer fits into this side.
Put one of the smaller nuts into place on the new spring assembly and screw the wheel axial into place.
Repeat this for the other side of the wheel axial. The wheel axial once completed will look like this.
Position the wheels back onto the scooter, making sure that the spring slots into the hole on the base.
Put the plastic guard back into place.
Put the metal plate back onto the scooter.