How To Replace The Steering Spring On Your RGS-0 And RGS-1 Kids Scooter
How to Replace the Steering Spring on Your RGS-0 and RGS-1 3Style Scooter
Step 1:
Using an Allen Key that came in the pack with your 3Style Scooter, unscrew the bolts and screws on the fender plate on the underside of your scooter.
Step 2:
Take the fender plate off
Step 3:
Take the steering assembly off from the scooter.
Step 4:
Using an Allen key, secure the screw that holds the steering spring in place. Then, use a second Allen key to loosen the bolt on the opposite side.
Step 5:
Remove the screw from the steering assembly. Then, use an Allen key to push the shank bolt through the steering spring.
Step 6:
Remove the metal plate covering the steering spring by pulling on it. Then, remove the steering spring.
Step 7:
With your new steering spring, place it back onto the centre of the assembly.
Step 8:
This part can be a bit fiddly! Position the metal plate back onto the steering spring, making sure its aligned properly. Push down hard to ensure it's in place.
Step 9:
Place the long shank bolt into the steering assembly.
Step 10:
Place the screw back onto the other side of the steering spring and twist clockwise to tighten.
Step 11:
Using the same method as before, hold one Allen key steady against the metal plate while you tighten the screw on the opposite side with another Allen key.
Step 12:
Place the steering assembly back onto the bolts at the bottom of the scooter. Make sure the holes are aligned properly.
Step 13:
Place the fender plate back onto the bottom of the scooter. Make sure all the holes are lined up.
Step 14:
Place the screws and bolts back into the fender plate.
Step 15:
Using the flat side of the Allen key, tighten the bolts back in place.
Step 16:
Using the pointed side of an Allen key, tighten the screws back in place.
You're all set! Happy Scooting!
Parts: