Installing RGS-2 Brake
Tools Required For This Repair
For this repair you will need a Philip head screwdriver and the large sized Allen key provided in the box of your original order.
Step 1
Place your RGS-2 3Style scooter upside down on a table or similar surface.
Step 2
Remove the 8 screws located on the base of the scooter.
Step 3
Once the screws have been removed, turn the scooter the right way up.
Step 4
Unfold the handlebars to the upright position.
Step 5
Lift the coloured plastic up over the brake as shown in this picture. This will then expose the screws keeping the brake in place.
Step 6
Remove both of these screws.
Step 7
Remove the brake or the remainder of the brake if this has snapped off.
Step 8
Once the brake has been removed, stand the scooter on the handlebars so that the rear wheel is facing upwards. Then pull out the bottom block of the brake.
Step 9
The RGS-2 brake block will look like this.
Step 10
Put the new brake block into place.
Step 12
Put the small nuts of the replacement screws into the recess of the brake block and hold these into place so that they don’t fall out.
Step 13
While still holding the nuts in place with one hand, use your other hand to screw the new brake securely onto the scooter.
Step 14
Once the brake has been attached, push the top part of the base back into place.
Make sure to align the recess for the screws in place with the holes on the bottom part of the scooter base.
Step 15
Screw the 8 screws back into the base of the scooter to secure to join the top and bottom part of the base.
Within Your Warranty?
Please contact our customer service team who will be more than happy to help assist with any parts you may require. To go to our contact form click "Get In Touch" on our header menu
Outside of Your Warranty?
Please visit our parts shop on our website where we sell a range of parts at a low cost or you can select the images in the steps with "Click Me For Part" to go directly to the part shown in the image.