Installing Spring On Assembly
Installing The Spring On The Assembly
Tools Required For This Repair
For this repair you will need a Philip head screwdriver and the medium sized Allen key provided in the box of your original order.
Step 1
Place your 3Style Scooter on a table or similar surface upside-down, this will allow you to have easy access to the bottom of the front of the scooter/steering column.
Step 2
Remove the two shank bolts located at the top going through the metal plate.
Step 3
Then remove the small screws which also go through the metal fender plate.
Step 4
Take off the metal fender plate.
Step 5
Remove the plastic guard.
Step 6
Pull the wheel shank axle off from the base and put these to one side.
Step 7
If the spring is stuck in your scooter, remove this as well. You can use one of your allen keys to gently ease this out.
Step 8
Once the spring has been removed, set aside the scooter for now and retrieve your wheel shank axle.
Step 9
Remove the one of the small screws from the metal plate on the spring assembly.
Step 10
Loosen the other screw slightly to enable you to rotate the metal plate, exposing the spring.
Step 11
Remove the remainder of the spring from the assembly. To help do this use a screwdriver or something similar to ease this out. This needs to be pulled out from the side with the metal plate.
Step 12
Once the remainder of the spring has been removed you can insert the new spring.
Push through the smaller end of the spring through the side of the assembly which had the metal plate on.
Push through the smaller end of the spring through the side of the assembly which had the metal plate on.
Step 13
The spring needs to be pushed in as far as possible so that it’s flush with the plastic spring assembly. You can pull and twist the spring to pull it further into the assembly.
Step 14
Next position the metal plate back over the spring and screw back in the small screw. Don’t forget to tighten up the screw that was loosened.
Step 15
Replace the wheel shank axle back onto the scooter making sure that the spring slots into the small hole under the scooters base.
Step 16
Put the plastic guard back into place.
Step 17
Position the metal plate back onto the scooter.
Step 18
Finally secure the shank bolts and small screws tightly into place.
Within Your Warranty?
Please contact our customer service team who will be more than happy to help assist with any parts you may require.
Click HERE to go to our contact form.
Outside of Your Warranty?
Please visit our parts shop on our website where we sell a range of parts at a low cost.
You can either click HERE to go to our parts shop or you can select the images in the steps with "Click Me For Part" to go directly to the part shown in the image.