Setting Up RGS-1 Scooter
Step 1
Place your RGS-1 3Style scooter on a table or similar surface.
Step 2
Open the clasp located at the base of the handlebars.
Step 3
Once the clasp is open, loosen the nut located on the other side of the handlebar stem.
Loosen the nut as much as you need to but do not remove this.
Step 4
Next pull up on the black latch to lift the screw and clasp out of the recess that’s keeping it in place.
Step 5
If this is stiff to lift up then you can push either side of the screw and clasp to lift this out.
Step 6
Once this has been pulled up you can then rotate the handlebar upwards, lifting them into the upright position.
Step 7
The black latch and the screw and clasp will spring down into the top recess keeping it in place.
Step 8
Please make sure this is fully pushed into the recess before tightening and closing the clasp.
Step 1:
Open up the collar clamp on the neck of your kids scooter.
Step 2:
Pull the handle bars up until the button on the side of your scooter clicks into a hole.
Step 3:
To adjust the handlebar height, press the metal button down and pull the handlebars upwards until the metal button clicks into the appropriate hole.
Step 4:
Close the collar clamp on the neck of the scooter.
You're all set! Happy Scooting!